TEF1126P-24-250W is a unmanaged PoE switch independently designed by Tenda. Compliant with IEEE802.3af and IEEE 802.3at standards, it can identify PoE-powered devices intelligently. With a maximum PoE power output of 230 W, and 30 W for a single port, it can supply power when transmitting data with APs, IP cameras, and IP phones. The switch supports 4 working modes, including standard, priority, extend and VLAN modes, is an ideal choice for SMBs, hotels, schools, factories with video surveillance and wireless networking requirements. ----------------- Standard&Protocol - IEEE802.3, IEEE802.3u, IEEE802.3ab, IEEE802.3z, IEEE802.3x, IEEE802.3af/at LED indicator - 24 * Link/Act LEDs 1 * G1 LED 1 * G2/SFP2 LED 1 * PoE-MAX LED 1 * Power LED Interface - 24 * 10/100 Mbps Base-TX RJ45 ports (Data/Power) 1 * 10/100/1000 Mbps Base-T RJ45 ports (Data) 1 * 1000 Mbps Base-X SFP port (Combo) Forwarding Rate - 6.55 Mpps Switching Capacity - 8.8 Gbps MAC Address Table - 16K Lightning Protection ?6KV Input Voltage - AC: 100-240V~50/60Hz
PoE Supply - Ports 1-24 support standard IEEE802.3af/at 30W output per PoE port 230W output of the total PoE Power Power Consumption - 250W output the whole device Dimension - 440*178.8*44mm Four Modes - Standard: Default mode of the switch. In this mode, it works as an unmanaged switch all ports can communicate with each other separately. Priority: In this mode, port G1 and G2/SFP2 serve as uplink ports, ports 1 – 8 serve as high priority port. All ports can communicate with each other separately. Extend: In this mode, data rate of ports 17 - 24 reduces to 10 Mbps, the maximum transmission distance can be 250 meters, and all ports can communicate with each other. VLAN: In this mode, ports 1 - 24 of the switch can communicate with port G1, G2/SFP2 separately, but cannot communicate with each other. You can enable this mode to reduce broadcast storm and isolate DHCP broadcast.